A dangerous goods shipping checklist is the last look a shipper takes at a hazmat consignment before the carrier drives away with it: is each product what the paperwork says it is, is it packed in packaging rated for it, are the right marks and labels on every package, does the paperwork match the dock, is the emergency number answered, and is it loaded so nothing incompatible ends up side by side. This form walks that check in order, shows only the road, air or sea questions that apply, and ends with an accepted, held or rejected result signed by the person who did it. Fill it in here and download the PDF, no account needed — or speak while you walk the dock, and the document writes itself.
The rules that apply — and what this form is not
Dangerous goods are regulated by mode and by country. In the US, road, rail, air and water shipments fall under the hazardous materials regulations in 49 CFR Parts 171 to 180. Air shipments are also governed by the ICAO Technical Instructions, which airlines apply through the IATA Dangerous Goods Regulations. Sea shipments follow the IMDG Code. Road transport in Europe and many neighboring countries follows ADR, and other countries have their own road codes.
Those rules decide what is required. This checklist does not satisfy any of them on its own and does not certify a consignment as compliant. It is a record of what the shipper's trained person checked before handing the consignment over. Classification, packing, marking, labeling and documentation remain the shipper's responsibility, and the person signing must be trained for the modes and classes involved and must work from the current edition of the rules.
Walk it in the order the consignment was built
Start with what is being shipped — each entry's UN number, proper shipping name, class and packing group, checked against the safety data sheet. Then the packaging, the marks and labels, the paperwork, and finally how it is loaded. Working in that order means a wrong classification is caught before anyone checks labels that would have been wrong too.
The modes question at the top decides what else appears. Tick road and the placard, driver and vehicle checks show. Tick air and the aircraft-type and declaration checks show. Tick sea and the container packing and four-side placard checks show. A consignment that goes by road to a port and then by sea gets both.
Limited and excepted quantities
Small quantities packed to tighter limits can travel with fewer requirements — a limited quantity mark instead of hazard labels, for example, or an excepted quantity mark for very small amounts. The relief is real but conditional: the quantity per inner packaging and per package has to be within the limit for that entry and that mode, and some relief does not apply by air.
Answer the quantity status question and the marks section changes to match: hazard labels and UN numbers for fully regulated goods, the limited quantity mark for limited quantities, the excepted quantity mark for excepted ones.
Why carriers turn consignments away
Most refusals are not about the chemistry. They are about details a careful check catches:
- A package count or quantity on the paperwork that does not match the dock.
- A trade name used where the proper shipping name should be.
- A subsidiary hazard label missing, or a label folded round a corner.
- An emergency phone number that goes to voicemail out of hours.
- Packaging whose UN mark does not cover the packing group inside, or packed differently from how it was tested.
- Orientation arrows missing from boxes holding liquids.
Held or rejected
A consignment that fails a check should not leave until the problem is put right. Held means it can be fixed on the dock — relabel, repack, reprint the paperwork — and checked again. Rejected means it goes back to the warehouse, for example because the classification is in doubt or the packaging is damaged. Either way, each problem goes on the actions list with a named person and a date, and the result is signed.
Common questions
Who is responsible for a dangerous goods shipment?
The shipper. The shipper classifies, packs, marks, labels and documents the consignment and certifies it. Carriers and forwarders run their own acceptance checks, but those do not move the responsibility. Everyone who performs those tasks must be trained for them.
Does completing this checklist make my shipment compliant?
No. It records what was checked. Compliance is set by the rules for each mode — such as 49 CFR in the US, the IATA Dangerous Goods Regulations for air, the IMDG Code for sea and ADR for road in Europe — applied by a trained person working from the current edition.
How often does dangerous goods training need to be renewed?
It depends on the rules. Under the US hazardous materials regulations, recurrent training is due at least every three years; for air, the IATA rules expect it within the previous 24 months. Your employer's records should show the date for each person who signs.
What is the difference between a label and a placard?
Labels go on packages and show the hazard of what is inside. Placards are the larger signs on the vehicle, rail car or freight container, and whether they are needed depends on the class, the quantity and the mode.
How long should shipping papers and declarations be kept?
At least as long as the rules for each mode require — in the US, two years from when the carrier accepts the shipment, or three for hazardous waste — and longer if your own policy says so. Keeping this checklist with them shows how each consignment was checked.
Do lithium batteries count as dangerous goods?
Yes. Lithium ion and lithium metal cells and batteries are regulated, with different requirements depending on whether they are shipped on their own, packed with equipment or contained in it. Answer Yes to the lithium question and the form adds the checks that matter most.